VirtualBox using Hyper-v VHD image

Select Next.
Select Memory.
Select Use an existing hard drive.
Select Add icon and select the desired VHD.
Upon starting the virtual machine I received the following blue screen of death:
Error Message A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you’ve seen this stop error screen, restart your computer. If this screen appears again, follow these steps:
Check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. Check your hard drive to make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.
Technical information:
*** STOP: 0x0000007B (0x80786b58, 0xC0000034, 0x00000000, 0x00000000)
The issue is that hyper-v will only build a bootable IDE hard drive. So when you create your virtual machine you need to make sure that you are not booting the VHD under a SATA Controller
but instead use the IDE Controller


Popular Posts